P0443 · blink 76 – Vsv For Evaporative Emission Control System Purge Con

System: Engine control (EFI)
Dashboard light: Check engine light (MIL)
Check-engine blink code: 76
Applies to: 1KR-FE: M300 (Sirion export = JDM Boon M300S/M301S(4WD? see gaps) & Passo KGC10/KGC15). JDM-spec ECU not separately documented | K3-VE: M301 (Sirion 1.3 = JDM Boon M310S? / Passo QNC10)
Description: Vsv For Evaporative Emission Control System Purge Con
Detection / symptoms: Detection: 1.When the detection signal of the VSV for evaporative emission purge is not turned "ON" or "OFF"
Possible causes: Trouble area: 1.VSV for evaporative emission control system purge control (Purge VSV for EVAP) 2.Open wire or short circuit for the evaporative emission purge VSV control system circuit 3.EFI ECU
What to check: Checking points: 1.Is the harness between the VSV for evaporative emission purge and the EFI ECU normal? 2.Is the control signal of the VSV for evaporative emission purge outputted from the EFI ECU normally? 3.Is the VSV for evaporative emission purge operating normally?; Unit check B8-224: purge VSV 30-34 ohm @20C
Confidence: high (factory manual, export spec)

From the factory service material. Clear the code and test-drive to confirm it returns. Search all fault codes · Common problems · Warning lights